How To Build A Floating Wall With Metal Studs

First you should check with your local authority to make.

How to build a floating wall with metal studs. For the height of the stud measure from the bottom of the floor joist of the room above to the top of the stacked 2x4 s and then subtract 3 inches. Fasten steel tracks to concrete using 1 1 4 in. Floating walls with metal studs they make a deep leg track for that purpose. Use a hammer drill fitted with a carbide tipped masonry bit.

Then measure from the ceiling to the floor joist above to determine the length of the studs image 2. Measure the length of the area for the wall. Subtract 3 from that measurement to account for the top and bottom plates one 2x4 on top and one 2x4 on bottom. When you ve decorated your new wall it ll look like an integral part of your house.

When you re done lift up your wall and then set it up on your pressure treated plate. Overview of the construction of floating walls in a basement a few additional framing and fire blocking details. Layout your wall on the floor line up your studs with the x s you marked out earlier and nail your studs in from the top and bottom of your plates. After that you attach the wall to the ceiling so that the frame is floating.

You want 1 stud for every 36 inches. Step 1 using a stud finder locate the studs in the wall where you want to hang the shelf step 2 slide the stud finder along the wall until it signals a metal stud. You fasten your studs to the bottom plate but just friction fit them on top. Lay out the position of the track strike chalk lines and drill a hole through the metal and into the concrete the full length of the screw.

You use a regular track on the bottom and the deep leg on top. Transfer this number to the metal studs and cut them. Snap a chalk line along the marks image 1. By doing it this way you are avoiding having to place shims in between your top plate and the ceiling joists.

Then you build your wall frame as usual but an inch or 2 inches shorter than it needs to be. So there is a space between the two plates. Building one is a fairly straightforward job but there are some things you ll need to think about before you start.