How To Cut And Install Wall Paneling

Measure the wall to check what size you need the plastic wall panels to be.

How to cut and install wall paneling. Once your panels are installed you will likely need to mount things to your wall such as units showers or other items. Panels usually come in manageable sections that you either glue or nail to the room s walls. Equipment you will need to use in. What you use to cut the panel depends on the type of panel itself.

Pull the bottom edge of the panel about 6 inches from the. Next measure out the wall panel itself with the finished side up and mark the measurements onto the surface of the panel. Position the panel on the wall leaving a 1 4 inch space at the bottom and drive the four nails partway into the wall. Place the template on the panel in the correct location and trace around it with a pencil.

If the plastic is softer you should be able to use tin snips. Remember to use the safety goggles when using these tools. Strips of masking tape will help protect the edges while cutting the panels down to the required size. Install a panel cutting blade a laminate blade or a cabinetmaker s crosscut blade on a table saw.

The configuration of frp boards specifies the use of special blades to complete the cut. A paneling project can go pretty quickly until you run into an electrical outlet. On the one hand the safety standards need to make on the top authority as the flying debris cuts and frp dust could appear in the air. To fit on these walls the frp panels need to be cut precisely during the frp installation process.

Take your panel and lay it flat on supports with the front facing up then mark out the cutting lines on the panel. Raise the blade to 1 inch from the tip of the highest tooth to the point where the blade emerges. If it s hard plastic you ll need to use a hacksaw. How to cut the frp panels.

Drive four finishing nails through the top edge of the panel. Using the electric saw carefully remove the excess wall panel. This may seem complicated since exact measurements are required. Make cutouts for any wall plates outlets or electrical boxes in panels as needed using a saber saw equipped with a fine cutting blade.

Make a paper template of any openings. Mounting to your walls. An opening for the outlet must be cut into the paneling before you install it on the wall.