Installing Led Strip Lights In Ceiling

This will hide the led tape but still give you the full lighting effect for a much sleeker look.

Installing led strip lights in ceiling. Slide the end of the strip into one end of a connector clip and snap it shut. Use a sharp knife to make a slit along the black lines between the light and the end of the led strip. Place a connector in the other side of the clip so the strip can lay flush along the corners. Yes led strip lights are designed to be easy to cut apart with a pair of scissors so you can trim them to the size you need.

To install your led strip lights on a ceiling or wall you ll need to make sure they re installed behind a lip such as the edge of a drop down ceiling or at the top of moulded coving. Trailer life and motorhome magazines bob livingston and bill gehr show you how to brighten the the exterior of your rv by installing led strip lighting. This will help you to hide the ceiling led strips lights and provide the best lighting effect in the living space for a much sleeker look. Led tape can be fitted horizontally facing upwards.

Look for the pair of copper dots at the end of each led and be sure to cut between the dots so you don t disconnect any wires that power the lights. Installing rgb led strip lights decorative ceiling led lights measure the space where you will install the rgb led strip lights cut the proper length for the space where you are installing. Peel the top layer off to expose the ends. How to install led strip lights under cabinets.

So install the led lightning ceiling strips behind a lip such as at the top of a molded or an edge of a drop down ceiling. When installing your strip lights there are two options for positioning the led tape. Installing led strip is very easy but if you are installing the strips in the ceiling you may need a lip to hide the led strips. The design of drop down ceilings can vary but they re typically suspended with a drop of around 10cm 15cm and the same distance from the surrounding walls.

Remember to put a masking tape at the end of each piece for better recognition. Start by cutting your strips to size then attach them to your ceiling.